Eeprom Factory Default Data Setup Procedure - Panasonic WH-MHF09G3E5 Service Manual

14.7 EEPROM Factory Default Data Setup Procedure

1 This process should be done at Gemstar (and/or) PAPAMY as the last process after any inspection.
2 This condition should be activated by pressing combination of few SW's for certain time as shown.
3 When this condition is activated, default data should be written in EEPROM.
4 Once the default data is written in the EEPROM, the following full LCD display should be ON for 2secs for
confirmation. After 2secs, it goes back to normal display.
These 3 SW's should press continuously for 5secs.
(Operation should be OFF during this period)
OPERATION
77
ACTUAL