Table of Contents
Advertisement
PIVOT PLATES TO PIVOT BAR
IMPORTANT! Before assembling pivot plates to
ends of pivot bar, pivot plate orientation and pivot
hole position must be determined using the following
procedure.
Before measuring the vehicle mount height, vehicle
mount and receiver brackets must be installed, ballast
must be installed if required, and the vehicle must be
parked on a level surface.
1. Measure the distance "d" from the ground to the
top edge of the receiver bracket. Measure both
sides and determine average value "d".
Top Edge of
Receiver
d
Lit. No. 64369, Rev. 04
INSTALLATION INSTRUCTIONS
9
2. Use dimension "d" from Step 1, and the following
chart to determine the proper pivot plate mounting
position and pivot hole selection.
Pivot Plate Confi guration Chart
Dimension "d"
13.0" – 14.5"
14.5" – 16.0"
16.0" – 17.5"
3. Position the snowplow with the A-frame level
(support bottom of the pivot bar 9" above fl oor).
Confi guration
1
2
3
June 15, 2010
Advertisement
Table of Contents
