Table of Contents
Advertisement
9. Install the clamp base, double hose clamp,
5/16" washer and 5/16" locknut loosely on the
weld stud on lower lift frame cross tube near lift
ram.
10. Install a split rubber hose sleeve on each 36" hose
just above the mark made in Step 6.
11. Orient clamp and base as shown and install hoses
in their respective side of clamp with sleeves
centered in clamp and sleeve openings to inside
of clamp. Tighten clamp. Final position of clamp
should be approximately 20° clockwise from
horizontal. Proper positioning of the hoses in the
clamp is necessary to allow complete movement
of the snowplow without stressing the hoses.
12. If necessary, realign clamp and fi ttings so hoses
do not contact snowplow frame, mount or vehicle.
Clamp
Base
Approx.
20°
Sleeve
Lit. No. 64369, Rev. 04
INSTALLATION INSTRUCTIONS
5/16" Washer w/
5/16" Locknut
Double
Hose Clamp
Passenger's
Driver's
Side
Side
HEADLAMPS
Headlamps and hardware are found in the headlamp
box. Additional hardware (1-7/8" OD fl at washer) is
found in the hydraulics box.
1. With wire harness behind lift frame, attach
headlamps to hole in headlamp channel
(not in slot) with headlamp swivel on top and
9/16" x 1-7/8" OD fl at washer, 1/2" lock washer
and 1/2" locknut underneath.
Headlamp Swivel
1-7/8" OD
Flat
Washer
(Found in
Hydraulic
Box)
1/2" Lock
Washer
1/2" Nut
Headlamp
Swivel
Cable Boot
Battery Cable
Headlamp
Harness
16
Grommet
Cable Tie
Anchor
Black/Orange Wire
(+)
(–)
Black/Red
Battery
Cable
Black
Battery
Cable
June 15, 2010
Advertisement
Table of Contents
