Table of Contents
Advertisement
Headlamp
Harness
Grommet
Cable Tie
Cable
Anchors
Tie
2. Insert seven cable tie anchors into 1/4" holes on
rear of headlamp channel from inside channel,
with locking tabs horizontal.
3. Install a split rubber grommet on each headlamp
wire 3" from headlamp and insert grommet and
wire into slot on rear of channel.
4. Route wires underneath channel, in back of
vertical supports, and down along inside of
driver-side vertical support, securing wires to
anchors with cable ties.
5. Attach harness to front of hydraulic unit cross
member at driver-side vertical support with a cable
tie through hole in cross member.
6. Route the black/orange wire with the ring terminal
to the motor ground stud.
NOTE: Use dielectric grease to prevent corrosion
on all connections. Fill receptacles and lightly
coat ring terminals and blades before assembly.
Lit. No. 64369, Rev. 04
INSTALLATION INSTRUCTIONS
Black/Orange Wires
Snowplow Control
Harness
SNOWPLOW CONTROL HARNESS
NOTE: Dielectric grease has been applied to coil
terminals. DO NOT wipe off terminals.
1. With the harness strain relief located at lower rear
corner of the valve block, attach a black/orange
wire to each valve coil.
2. Attach white/yellow wire to front coil, green wire to
center coil, and blue wire to rear coil. See diagram
below.
2-Way
White/Yellow Wire
Black/Orange Wire to Each Coil
3. Route wires under valve coils and reinstall the
valve cover with the harness strain relief inside the
cover harness slot. Avoid pinching wires between
the cover and coils or valve block. Attach the
cover with two 2-1/2" standoff screws. Apply anti-
seize to screw threads.
4. Route the black/orange wire with ring terminal to
the motor ground stud.
NOTE: Snowplow lighting and control harnesses
plug into one another for storage.
17
3-Way
4-Way
Green Wire
Blue Wire
June 15, 2010
Advertisement
Table of Contents
