Table of Contents
Advertisement
SNOWPLOW BATTERY CABLE
Parts installed in this section are found in the
hydraulics box.
1. Attach black/red battery cable to the POSITIVE (+)
motor stud on the hydraulic unit.
2. Attach black battery cable and the two black/orange
wires from the headlamp and control harnesses to
motor NEGATIVE (–) ground stud.
3. Tighten both stud nuts to 50–60 in-lb. Do not allow
stud to rotate while tightening.
4. Install cable boot over bracket on driver's side of
the lift frame.
5. Insert battery cable connector in cable boot for
storage.
Lit. No. 64369, Rev. 04
INSTALLATION INSTRUCTIONS
18
BLADE GUIDE ASSEMBLY
Attach a blade guide to each outer rib using
5/16" x 1" cap screws and locknuts as shown.
Blade Guide
5/16" x 1"
Cap Screws
5/16"
Locknuts
June 15, 2010
Advertisement
Table of Contents
