Laars MagnaTherm HTD Series Installation And Operation Instructions Manual page 7

HTD
WARNING
Electrical Shock Hazard
Electrical shock can cause severe injury, death or
property damage. Disconnect the power supply before
beginning installation or changing the wiring to prevent
electrical shock or damage to the equipment. It may be
necessary to turn off more than one power supply
to disconnect.
All electrical wiring is to be done in accordance with
local codes, or in the absence of local codes, with: 1)
The National Electrical Code ANSI/NFPA No. 70 - latest
Edition, or 2) CSA STD. C22.1 "Canadian Electrical Code
- Part 1." This appliance must be electrically grounded in
accordance with these codes.
WARNING
The Repair Parts list designates parts that contain
refractory ceramic fi bers (RCF). RCF has been classifi ed
as a possible human carcinogen. When exposed to
temperatures above 180ºF, such as during direct fl ame
contact, RCF changes into crystalline silica, a known
carcinogen. When disturbed as a result of servicing or
repair, these substances become airborne and, if inhaled,
may be hazardous to your health.
Do not remove or replace RCF parts or attempt any
service or repair work involving RCF without wearing
the following protective gear:
1. A National Institute for Occupational Safety and
Health (NIOSH) approved respirator.
2. Long sleeved, loose fi tting clothing.
3. Gloves.
4. Eye Protection.
The supply voltage to this unit must not be
disengaged, except for service or isolation, or
unless otherwise instructed by procedures outlined
in this manual. To signal a call for heat, use the
correct terminals as instructed in the Electrical
Connections, Field Wiring 7.D on page 35 of this
manual.
CAUTION
NOTE: All installations must be made in accordance with
1) American National Standard Z223.1/NFPA54-Latest
Edition "National Fuel Gas Code" or
2) CSA B149.1 "Natural Gas and Propane Installation
Code" or in Canada reference the B149.1 latest
edition and with the requirement of the local utility or
other authorities having jurisdiction. Such applicable
requirements take precedence over the general
instructions contained herein. All electrical wiring is to
be done in accordance with the local codes, or in the
absence of local codes, with: 1) The National Electrical
Code ANSI/NFPA No. 70-latest Edition, or
2) CSA STD. C22.1 "Canadian Electrical Code - Part
1". This appliance must be electrically grounded in
accordance with these codes.
Page 3