GOLDEN MASK DEEP HUNTER Pro3 Instruction Manual page 9

GM Electronics Ltd.
To charge the built battery:
1. Turn "Off." the detector, remove the antenna jack and plug the charger jack in the
connector labeled "Charge" on the front panel of the device.
2. Place the detector in an upright position near a power outlet with voltage 90 ÷ 240V
and connect the automatic charger into the outlet.
The charging is indicated with a RED-color LED light on the charger housing.
When the charging process is completed, the LED light turns blue.
The duration of charge of an empty battery is about 10 ÷ 12 hours.
When the charge is completed, remove the charger from the power socket and then
remove the charger jack from the connector "Charge".
3. Turn "On" the detector and check the charge level by pressing "Battery Check"
button. With a properly charged battery, the arm of the indicator must show a value
greater than "7".
If the reading is lower than 7, reconnect the charger and repeat the charging process!
12. Replacement of the built-in battery
To replace the battery, you should contact the dealer the device was purchased from.
The dealer will provide information on the rules and the conditions for battery
replacement - warranty and post warranty.
Never replace the battery without consulting your dealer. Replacing the battery with a
non-genuine one could damage the detector and leads to warranty void!
13. Relative depth of detecting of metal objects in different modes
Golden Mask Deep Hunter Pro3 enables the operator to combine the settings of the
device and its use in 4 different modes of operation.
When working on "heavy soil" sites, modes with a lower number are preferred.
Golden Mask Deep Hunter Pro3 – Instruction Manual
9