CEBEK TL-3 Quick Start Manual

The TL-3 is a 1 channel remote control receiver supplied by 12 VDC with relay output working by radiofrequency. It will recognise the signal
from TL-5 or TL-6 emitters, verify the security code and maintain the output connected until you stop to press the push button of the emitter.
You could configure your own security code (between 13.122 possibilities) as well as to work with theTL-5 or the TL-6 emitters.
It includes micro-switches to select the code, antenna output, led and acoustic signal for the output as well as connection terminals.
Don't forget to read all the information sheet in order to obtain a perfect operating of the module.
OPERATING
POWER SUPPLY.
The TL-3 circuit had to be supplied with voltage from 230 VAC. According to the General Wiring Map you have to
use an adequate plug and a cable for mains and connect it to the input terminal 220 VAC. Install a fuse and a switch as it is indicated in
General Wiring Map (see hereafter). Both are necessary to protect the module and for your own security, as it is indicated in "CE"
regulations. Then, verify that you have correctly connected the module.
Before to connect the module to the mains inserting voltage, please do the rest of connections specified hereafter. Don't forget that in
several part of the module there is voltage (230 VAC), for this reason we suggest you to be careful.
OPERATING.
Although the circuit's operating is very easy, do not forget following points:
All CEBEK remote control works with a frequency adjusted at 433.92 MHz. For this reason, they include microswitches (INT-1) allowing to
configure a security code between 13.122 possibilities, for each module. Then, your module will be different from others, even if they offer
same characteristics.
Seeing the drawing map, you could note that the micro-switches INT-1 have 8 switches with three different positions: "-", "0" and "+". You
have to modify the switches position that you have received in order to select you personal code
Note that for there to be communication with the issuer, it must be configured with the same code used in the receiver
ANTENNA INSTALLATION.
"General Wiring map", install a metallic antenna with a length of 130 mm. The cable between antenna and module had to be shielded and
inferior than 25 cm. Connect the negative terminal to the ground.
OUTPUT CONFIGURATION.
module), it also could be controlled by the TL-6 module: 2 Channels emitter. Then, you have to select between two push buttons the
wished receiver output.
From the factory, the TL-3 module is supplied to be controlled by the TL-5 module (with 1 channel) with a single
To obtain a maximum and clear reception, you have to install an exterior antenna. Seeing the paragraph
Even if the receiver TL-3 have been developed to control its corresponding emitter with 1 channel (TL-5
1 CHANNEL REMOTE
CONTROL RECEIVER
TL-3
CHARACTERISTICS
Voltage......................................... 230 V. A.C.
Minimum Consumption ............... 15 mA.
Maximum Consumption ...............55 mA.
Operating Frequency .................. 433.92 Mhz.
Maximum Distance (Approx.) ......30 Meters.
Maximum Output Load.................3 A.