Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Neets Control LiMa
Summary of Contents for Neets Control LiMa
- Page 1 Neets Control - LiMa Installation Manual...
-
Page 2: Foreword
Foreword This document describes how to install and operate the Neets Control - LiMa. COPYRIGHT - All information contained in this manual is the intellectual property and copyrighted material of Neets. All rights are reserved. You may not allow any third party access to content, information or data in this manual without Neets’... -
Page 3: Important Safety Instructions
Important Safety Instructions Caution: Read these instructions. Read and understand all safety and operating instructions before using the equipment. Keep these Instructions. The safety instructions should be kept for future reference. Heed all warnings. Follow all warnings and instructions marked on the equipment or in the user information. Avoid attachments. -
Page 4: Table Of Contents
PoE power supply to LiMa ........ -
Page 5: Specifications
USB port for programming PIR sensor input Light on/off Room darkening Screen up/down Volume control Device feedback Specifications Neets Control - LiMa RS-232 / IR port PoE input Ports 2 x bidirectional Compliance 802.3af / 802.3at Baud rate 1200 - 115200 bit/sec 802.3af PD mode... -
Page 6: Installation
Installation The Neets Control – LiMa is designed to be easily installed in any convenient location. The unit can be placed on a desk free standing. Simply unpack the unit, mount the adhesive feet and it is ready to go. -
Page 7: Connection And Controls
802.3af and 802.3at, type 1 in order to configure it by USB. The USB connector for connecting to the LiMa is “mini USB B 5P”. You can buy this cable on the web (select a USB A to Mini USB B 5P). -
Page 8: Back
LiMa. Be aware that you can activate multiple relays at the same time and damage connected equipment if not carefull. uSD-Card The uSD-Card stores the LiMa project setup created in the Project control in / out relay Designer software, including general settings and Graphical User Interface. - Page 9 Relays Relays are used when a external control is needed where there must be potential free connection between the control and the LiMa. The relays are normally open types. This means that the terminals are not connected when the relay is off.
- Page 10 The LiMa has Power over Ethernet functionality built into the LAN interface connector. You must connect the LiMa to your LAN if you are using any of the LAN features of the product. The port features auto MDI-X which means that...
-
Page 11: How To Connect
How to connect PoE power supply to LiMa To power up the LiMa, the LAN connector marked with PoE IN should be connected to a compliant PoE power supply. Or you can use the PoE Injector (Part number 302-000508). Connect the PoE Injector LAN connector marked “POE”... -
Page 12: Troubleshooting
Troubleshooting Error indication using LEDs If there is a fault in either the configuration or the Neets Control - LiMa unit, this will be indicated on the front LED indicators. In all error modes the power LED will flash red alternating with the IO LEDs. The alternating IO LEDs will indicate type of error.
Need help?
Do you have a question about the LiMa and is the answer not in the manual?
Questions and answers