Components - Ranger RML-600XL Installation And Operation Manual

Components

The main components of the RML-600XL ATV/Motorcycle Lift include:
• Platform. The flat section on which you put the ATV or Motorcycle. Includes the Clamp (for
clamping the front tire).
• Scissor Arms. Under the Platform, they move up as the Platform is raised and move down as
the Platform is lowered. Scissor Arms hold the Safety Locks.
• Safety Lock Release Handle. Moves the Safety Lock Rod off the Safety Locks, allowing you to
lower the Platform. Has a red ball on its end, making it easy to see.
• Safety Locks. Hold the Lift in position at the desired height once engaged. The five Safety Locks
are on the Scissor Arms.
• Safety Lock Latch. Located on the underside of the Platform, it holds the Safety Lock Release
Handle up and out of the way as you lower the Platform.
• Ramps. One Main Ramp for the Platform. Two Side Extension Ramps, one for each Side
Extension. The Ramps are not load bearing; do not raise the Lift with any weight on any Ramp.
• Cylinder. Raises and Lowers the Platform using pneumatic energy from the Air Pump.
Not to scale. Mixes side and top views. Platform Extension not installed. Back set of Scissor Arms
not shown for clarity.
RML-600XL ATV / Motorcycle Lift
7
P/N 5900381 — Rev. D — June 2019