Maintenance; Troubleshooting - Ranger RML-600XL Installation And Operation Manual

Maintenance

⚠
WARNING
To maintain your Lift:
• Cleanliness. Make sure to keep the Lift clean and free of debris and dirt. Wipe it down after
each use; remove any grease, dirt, or other debris.
• Clamp Assembly. Be careful not to bump or bend the Clamp Assembly. If bent, it may not work
correctly.

Troubleshooting

Issue
Platform does not go up.
Platform lowering on its own.
Lift is making odd noises as it raises
and lowers.
Lift wobbles as it raises or lowers.
Lift becomes inoperative with
Vehicle raised on the Lift.
RML-600XL ATV / Motorcycle Lift
Disconnect the Air Pump from the Air Supply (if connected) before performing
any maintenance. Make sure to clear all of the air pressure out of the system
before beginning maintenance.
Action to Take
Make sure you have a working Air Supply attached.
Make sure the Air Hose is connected to the Cylinder and to
the Air Pump.
Make sure the Lift has 1000 pounds / 454 kg or less on it. Do
not overload the Lift.
Make sure the Platform is engaged on Safety Locks.
Make sure the Lift is not overloaded.
Lubricate hinge points using white lithium grease. Zerk
grease fittings are located at lubrication points on the Lift.
Make sure the Vehicle on the Lift is secure and balanced.
If Platform is engaged on Safety Locks, the Platform will stay
raised. To lower it, use another lifting device to raise the
Vehicle off the Platform a few inches, raise the Platform to
get it off its Safety Locks, put the Vehicle back onto the
Platform, then lower the Platform to the ground. Once the
Vehicle is safely off the Platform, take the Lift out of service,
determine the source of the problem, resolve the problem
yourself, visit www.bendpak.com/support/, or call BendPak
Ranger at (805) 933-9970. Do not put the Lift back into
service until the issue has been resolved.
20
P/N 5900381 — Rev. D — June 2019