Planet Networking & Communication IHD-210PR User Manual page 38

Q9: What's the maximum of Rx units can be linked via one Tx unit?
A:
Theoretically, 1000 are the most, as long as each Rx unit is assigned to an IP from 65534 IP.
Q10: Why did it fail when upgrading firmware?
A:
1. The IHD-210PT has a different firmware from the IHD-210PR; please choose the correct firmware
before upgrading firmware.
2. Do not interrupt the upgrading procedure.
3. User should upgrade firmware to every unit. (For example, if there are 3 Rx's, user should update
for 3 times.)
Q11: Why can't I send data via RS232?
A:
Please check the following:
1. The Tx and Rx should connect to each other successfully.
2. The baud rate of Tx and Rx should be the same.
Q12: How to restore IHD-210PT or IHD-210PR to factory default setting
A:
Please refer the steps below:
1. Power on the unit.
2. Press the hardware reset button for over one second.
3. The unit will reboot. When the unit is rebooting, the Channel LED will change to "- -"one second.
4. After rebooting, the unit will be back to factory default setting.
Q13: About HDCP issue.
A:
The system will disable the video output signal when it detects non-HDCP compliant display(s)
playing the HDCP video source. All the connected output displays must be HDCP compliant while the
video source is HDCP compliant.
Q14: Why is Full HD video source watched on a non Full HD monitor is so blur or choppy?
A:
We suggest user do not use the low-resolution monitor to watch the higher quality video source. The
screen resolution can only be backward compatible, not forward compatible. So please adjust the
video source resolution appropriate for the output screen resolution.
Q15: Why can't the Tx/Rx Device Selection load properly?
A:
The IP address of PC might be in a different subnet from Tx/Rx. Please set the PC's IP address in the
same subnet as Tx/Rx.
Q16: How to use IR extension on IHD-210PT and IHD-210PR
A:
Please refer the steps below:
1. Connect the IR emitter cable to IHD-210PT, and make IR emitter cable focus to video source
device.
2. Connect the IR receiver cable to IHD-210PR.
3. Power on IHD-210PT and IHD-210PR.
High Definition HDMI Extender over IP with PoE
38
IHD-210PT / IHD-210PR