Planet Networking & Communication IHD-210PR User Manual page 37

High Definition HDMI Extender over IP with PoE
IHD-210PT / IHD-210PR
just double-click on specified macro, and then the commands will be sent to the switch in a very short
time, thus swapping your video source. By the way, in this setting, all the transmitter(s) and receiver
should set as the same group.
Instructions about the topology above:
As for Test A, we set port1 and port3 to a VLAN, and set port2 and port4 to another VLAN. The Rx
will convert the source if we change the connection of Rx and switch from port3 to port4.
As for Test B, we set port1 and port3 to a VLAN, and the Rx will convert the source if we issue the
command via telnet to set port2 and port3 to a VLAN.
3. You also could use HDMI splitter (matrix) for converting the sources.
As you see, two sources are connected to the input of HDMI matrix and output to Tx, and then Tx and
Rx are all connected to the switch. In this case, we use the HDMI matrix controller to select the
source.
Q6: Users encounter no screen display in computer connection.
A:
1. Make sure the device cables are correctly and firmly attached.
2. Set your display device's (TV, monitor, etc.) input source as HDMI.
3. Check the PC BIOS configuration about the video output setting.
4. Connect HDMI monitor to the Tx's HDMI output port to check if the video signal gets through.
5. Slide the DIP switch to the correct position.
6. Please reboot or disconnect and connect again.
Q7: Why can't the IPTV Control Center find out IHD-210PT or IHD-210PR?
A:
Please check the following:
1. The PC installed IPTV Control Center is not in the same LAN as IHD-210PT or IHD-210PR.
2. The IP address of PC might be in a different subnet from Tx/Rx. Please set the PC's IP address in
the same subnet as Tx/Rx.
3. IPTV Control Center should be closed and run again when user changes the PC's IP address.
Q8: What's the maximum limit distance between input video source and output video?
A:
The maximum distance from the Tx to PoE switch and from the Rx to PoE switch is 100 meters.
So the maximum distance between Tx and Rx is 200 meters.
37