Advertisement
Sticking of the hull:
After everything works perfectly, the two pieces can be glued. Please note that the two
pieces can not be separated anymore.
It is important to pay attention to clean and grease-free adhesive surfaces. For safety,
clean the surfaces on the outside and on the inside with some solvent.
Apply the appropriate adhesive (we recommend a special adhesive silicone, as the
residues can be easily removed later) at least 5 mm even and circumferential thick. The
outer glue line is later no longer accessible.
Now press the lid onto the hull
.
In addition we recommend to rivet. It's best if the material spills out everywhere. Then the
hull is 100% tight.
Now it is essential to allow the boat to cure completely, because movements
(even in the water !!) can cause the joints to open and are only very difficult to
seal afterwards.
Finally, connect the cables to the main switch, GPS or echo sounder. The battery box only
has to be hung in the opening.
CONGRATULATIONS, now everything is ready.
Pay special attention to the individual instructions of the components, such as
Lipo - batteries, charger etc. and to the instructions of the boat.
You can always contact us if you have problems with the assembly.
Advertisement
