Advertisement
Mounting of the lid:
1. At first the attached LEDs are mounted.
The diodes supplied by us are pre-assembled and ready. These diodes are designed for
12 volts and only need to be screwed into the already milled holes of the hull.
During assembly, these should still be completely seale
d. Be sure to secure the sockets after the screwing, as this area of the boat will be difficult
to reach after gluing.
We recommend to connect the diodes parallel, because then the other diodes still work, if
one fails. That means bringing all + poles together and soldering all -poles together. In
this circuit, the "dimmable light relay" has to be installed as in the parts description /
sticker.
We recommend soldering the diodes directly to the boat batteries.
To do this, install a power take-off at the supply lines of the controller.
Lay the live cables around the outside, not in the center shaft.
As well the power supply for the GPS / echo sounder. This is important because the later
receiver sits in the middle shaft and does so not sit in the slipstream of the live cables.
Of course check the function completely before gluing.
Finished.
Advertisement
