Advertisement
We are pleased, that you have chosen the construction set of a CM bait
The individual parts are selected high-quality components, some of them
The hull is made of ABS, therefore it is very light and dimensionally stable, it can be easily
These instructions are intended to facilitate the assembly, but must be implemented by an
experienced modeler. Partly it can be that components are modified due to tolerances or
have to be installed otherwise. These instructions are only intended as a suggestion. There
All parts have been tested for their function before shipment. It is important to pay
attention to the correct connection of the individual components. In addition, the
instructions for use of the components must be read carefully and implemented right to
ensure the correct a use. For damages that are due to a non-professional use, we assume
Please read these instructions and later the operating instructions
carefully and completely before starting to work.
Generally, it makes sense to provide all screws with a screw lock.
First, the herb screen should be glued from the inside into the hall. As with all our bait
boats, we recommend as glue a MS polymer, special adhesive silicone available in almost
are specially made for these boats.
glued or repaired.
are several ways to complete the boat.
But now nothing should get in the way anymore:
Assembly of the hull:
1. Installation of the jet drive and the engine
The opening for the jet engine is already pre-milled.
every hardware store, e.g. Sikaflex.
boat.
no warranty.
Advertisement
