Areas Of Use; Starting And Operation; Filling With Petrol - Stiga PARK PRO 25 Instructions For Use Manual

4wd
Hide thumbs Also See for PARK PRO 25:
Table of Contents

Advertisement

3. Release the control lever (1:S) to lock the seat.
The seat is equipped with a safety switch that is
connected to the machine's safety system. This
means that certain dangerous activities are not pos-
sible when there is nobody sitting on the seat. Also
see 4.3.2.
2.4.18 Engine casing (7:U)
In order to access the fuel cock, battery
and engine, the machine has an engine
casing that can be opened. The engine cas-
ing is locked with a rubber strap.
The engine casing is opened as follows:
1. Undo the rubber strap (7:V) at the front edge of
the casing.
2. Carefully lift the engine casing back.
Close in the reverse order.
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.
2.4.19Quick-release mounting (34:H)
The quick-release mountings allow the
deck to be moved easily between the two
positions:
•Normal position with fully tensioned
belt.
• 4 cm behind the normal position with slackened
belt.
As the belt idler is released from the belt, the
quick-release mountings simplify belt and deck re-
placement, and also make shifting to the washing
position and service positions easier.
Releasing the belt tension:
1. Remove the locking pins (34:G) from both
sides.
2. Press down the rear section of the quick-release
mountings (34:F) with the lug.
3. Carry out necessary corrective action, e.g. set-
ting the deck to the washing position.
Tensioning the belt:
First tension one side and then the other according
to the instructions below.
Use protective gloves when handling the
lever. Risk of crushing injuries.
1. Firmly grasp the lever (35:J) in front of the cen-
tre of the shaft and carefully turn 180° forwards.
2. Install the locking pin (34:G).
3. Carry out the above on the other side.
ENGLISH

3 AREAS OF USE

The machine may only be used for the following
tasks using the genuine STIGA accessories stated.
Work
Mowing
Sweeping
Snow clearance
Grass clipping and
leaf collection
Grass and leaf
transport
Sand spreading
Weeding on gravel
paths
Lawn edge trim-
ming
Moss scarification Using moss scarifier.
The maximum vertical load on the towing hitch
must not exceed 100 N.
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.

4 STARTING AND OPERATION

The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.

4.1 Filling with petrol

Always use lead-free petrol. You must never use 2-
stroke petrol mixed with oil.
The tank holds 14 litres. The level can easily be
read through the transparent tank.
NOTE! Ordinary lead-free petrol is a perishable
and must not be stored for more than 30 days.
EN
Accessories, STIGA genuine
Using mowing decks:
95C, 95C El, 105C, 105C El,
121 M, 121 M El, 110 Combi
Pro, 110 Combi Pro El, 125
Combi Pro, 125 Combi Pro El
and with flail mower.
Using brush unit or collector
brush unit. The use of a dust
guard is recommended with the
first option.
Using snow blade or snow
thrower Snow chains are recom-
mended.
Using towed collector 30" or
42".
Using dump cart Standard, Maxi
or Combi.
Using sand spreader. Can also
be used for spreading salt. Snow
chains are recommended.
Using front-mounted hoe.
Using edge trimmer.
67

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Park pro svanPark pro 20Park pro 16

Table of Contents