Programming The Coffee Maker; Practical Hints - Team Kalorik TKG CM 1008 T Manual

Fax +32 2 359 95 50


PROGRAMMING THE COFFEE MAKER

To program your coffee maker to brew fresh coffee at a preset time, first follow steps 1 to 4 in
the "PREPARATION OF COFFEE" section.
Make sure the coffee maker's clock is set to the right time.
Press the PROGRAM button twice. The clock will now display 12:00 with the word "TIMER" in the
upper left corner. Use the HOUR and MIN buttons to set the desired brew time.
Press the POWER button twice to activate the preset brew cycle. The green AUTO light will
illuminate when the brew time is properly set.
When your preset brew time is reached and the coffee maker starts its brew cycle, the green
AUTO light will go out and the red ON light will illuminate.
As with the regular brew cycle, an automatic two hour keep-warm cycle will commence after
your coffee maker has finished brewing. At the end of the two hours, the coffee maker will
automatically shut itself off.
DECALCIFICATION AND CLEANING
 Before cleaning, turn off the appliance, unplug it and let it cool down.
 The filter, filter holder, carafe and carafe lid can be cleaned in a solution of warm water
and mild liquid soap.
 The coffee maker can be cleaned using a damp cloth. Never immerse the body of your
coffee maker in water or any other liquid. Never use abrasive cleaning products or
solvents.
 Decalcifying the coffee maker prolongs its life span. For decalcification only use products
especially made for the decalcification of coffee makers.
 Never use a dishwasher to clean the jug. Just clean it in soapsuds.
If the water in your region is hard, descale your coffee maker every 7 to 10 uses as follows:
 Pour 3 cups of clean vinegar into the water tank and then fill to the maximum level with
water.
 Place the carafe on the warming plate.
 Plug in the coffee maker and press the "power" button.
 When the water tank has emptied, switch off the coffee maker and empty the carafe.
 Rinse the coffee maker two or three times by repeating the above process using cold
water only.

PRACTICAL HINTS

When you notice that the coffee making process is longer than it should be, it is probably time
to decalcify the appliance. Do not wait until the situation gets worse. The decalcifying
frequency depends on the amount of lime in the water and therefore can be different from
family to family. Therefore it is important to pay attention to this. A good maintenance of your
appliance will prolong its lifespan. Guarantee claims will not be accepted for the replacement
of a heating element full of scale.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2012/19/EU
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/37
on the
TKG CM 1008 T - 140715