GMC CHEVROLET Silverado 6500HD 2019 Owner's Manual page 240

Passing Another Vehicle While
Using Cruise Control
Use the accelerator pedal to
increase the vehicle speed. When
you take your foot off the pedal, the
vehicle will slow down to the
previous set cruise speed. While
pressing the accelerator pedal or
shortly following the release to
override cruise control, briefly
pressing SET will result in cruise
control set to the current vehicle
speed.
Using Cruise Control on Hills
How well the cruise control works
on hills depends on the vehicle
speed, the load, and the steepness
of the hills. When going up steep
hills, pressing the accelerator pedal
may be necessary to maintain
vehicle speed.
While going downhill:
Cruise Grade Braking is enabled
when the vehicle is started and
cruise control is active. It is not
enabled in Range Selection
Mode. It assists in maintaining
driver selected speed when
driving on downhill grades by
using the engine and
transmission to slow the vehicle.
To disable and enable Cruise
Grade Braking for the current
ignition key cycle, press and
hold the Tow/Haul button for
five seconds. A DIC message
displays.
Cruise Grade Braking is enabled
when Tow/Haul Mode is on, the
exhaust brake is on, or both
are on.
For other forms of descent control,
see Tow/Haul Mode 0 227.
Driving and Operating
Ending Cruise Control
There are four ways to end cruise
control:
Step lightly on the brake pedal.
Press .
Shift the transmission to
N (Neutral).
To turn off cruise control,
press .
Erasing Speed Memory
The cruise control set speed is
erased from memory if
or the ignition is turned off.
239
is pressed