Power; Lan - Contec CONPROSYS nano CPSN-MCB271-S1-041 Reference Manual

Remote i/o cpu unit
Table of Contents

Advertisement

2 Setup

Power

Power Cable
Use the power cable described below.
- Cable : Twisted pair cable (when using a single wire, twist V+ wire and V- wire)
- Cable Diameter : AWG20-16 (0.5mm
- Cable Length : within 3 meters
FG Cable
Use the FG cable described below.
- Cable Diameter : AWG18-16 (0.75mm
Specification of external power supply
This product is designed to operate with 30 watt power supply depending on the number of configurable
modules.
In addition, the power supply must fulfill the following requirements.
- Rising time for up to 24 voltage: 2 milliseconds up till 30 milliseconds
Recommended power supply is CPS-PWD-30AW24-01 (by CONTEC).
CAUTION
-
If the maximum output current of the external power supply is smaller than the maximum
consumption current of this product, the abnormal operations might occur due to the inrush current
at the start-up time or the load fluctuation. The aging external power supply could cause a start-up
failure.
-
About a caution mark
Please use copper wires that tolerate the temperature of 75 degrees Celsius and higher.

LAN

Use the LAN cable described below.
- Category : Category 5 or more
- Cable Length : within 100 meters
26
2
2
-1.25mm
)
2
2
-1.25mm
)
on the product:
CPSN-MCB271-S1-041 Reference Manual (Hardware)

Advertisement

Table of Contents
loading

Table of Contents