LG RP1329A7S Owner's Manual page 37

2. Factory reset - EEPt
After a factory reset, all values are reset to the default values.
Entering set up
mode.
You will see LqC1
NOTE
• Dryer default value for CARD/COIN machine.
- Drying time 50 Minute
- Top off time 10 Minute
• Drying time in OPL machine can be changed from 10 to 100 Minutes by pressing the cycle button.
Press the Med Temp. or the Low Temp. Button until
appears in the display.
Press the Start button.
Press the Med Temp. button until
display.
Press the Start button, then factory reset is done.
is displayed.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/off toggle switch.
• OPL/Coin Type - Push "High Temp. " + "Low Temp. " and the '3' .
Button
appears in the
PROGRAMMING MODE
display
37