Table of Contents
Advertisement
(_2_.l_NS_Ti_A_LL_A_~l_O_N
__________ )
2.1 General
This section explains how to install the monitor and how to verify its basic
operation. The monitor is throughly adjusted and checked out at the factory,
but it may require certain minor adjustments to adapt it to a particular display
generator or other controller and to compensate for minor adjustment disturb-
ances caused during transportation.
Complete adjustment procedures and
other basic checks are described in section 4, and section 5, but only selected
simple procedures should be necessary for initial installation.
2.2 Unpacking
The monitor is normally packaged in a separated shipping container by
MITSUBISHI ELECTRIC CORPORATION.
Open the top of container, then remove the inside packing materials and lift
out the monitor
car~fu
I ly.
Accessories are placed at the bottom of container, and/or the top of packing
materials.
2.3 Installation Place
· The monitor should be placed away from the device which generates the
magnetic fields, eg. transformer and motor, because the magnetic fields
cause the miss-convergence.
• The sufficient ventilation is necessary for long time stable operation. So,
do not block the vents of cabinet.
· In order to get the excellent display image and prevent eye fatigue, it is
recommended to avoid the direct light shining to the screen of monitor.
7
Advertisement
Table of Contents
