Advertisement
Quick installation Guide
Configuring Network Settings via LCD Screen
The default network settings for the interSeptor Pro are as follow:
IP: 192.168.1.1
Subnet Mask: 255.255.0.0
Gateway: 192.168.1.254
To change these settings prior to network communication please follow
the following instructions:
1. Press the Set button on the front of the interSeptor Pro so System
Config displays on the LCD screen.
2. Press the Set button.
3. Press the Down button until IP Address displays on the LCD screen.
4. Press the Set button.
5. Either enter the required IP address for the interSeptor Pro or use the
default address (192.168.1.1). Press the Set button to increase or
decrease a number, and the Down button to move to the next number.
6. Press the Set and Down buttons simultaneously to exit the setting
menu once the IP address is entered.
7. Repeat steps 1-5 above to enter the subnet mask and gateway (listed
as Net Mask and Gateway in the system configuration menu).
8. Configure any of the other system configurations that are required, and
then select Back to Idle to complete the system setup.
It is now possible to access the interSeptor Pro via web
browser or telnet.
www.jacarta.co.uk
Note: Default Administrator
ID: iSPro
Password: admin
interSeptor Pro
2
Advertisement
