Banner Sure Cross Performance P15E Node Series Manual

Sure Cross Performance P15E Node
®
Datasheet
®
The Sure Cross wireless system is a radio frequency network with integrated I/O that operates in most environments to eliminate
the need for wiring runs.
The Performance Series P15E Node can wirelessly control any AC-powered devices, including lights (including dimming levels), fan
speed, and motors. For higher amperage applications, relays can be used to control contactors. By using a current transducer and
its analog inputs you can monitor energy/power levels for connected devices.
Benefits
• Remotely control—Lights, fans, and motors; use in conjunction with equipment health monitoring sensors to shut down
motors remotely when potential issues are detected
• Eliminate control wires—The Sure Cross wireless system is a radio frequency network with integrated I/O that removes the
need for control wires.
• Reduce complexity—Facility or machine reconfiguration made easier; great for retrofit applications
• Deploy easily—The relays and wireless radio are housed in a single device, simplifying installation on existing equipment
and enabling deployments in remote and hard-to-access locations where implementing a wired solution would be difficult,
impractical, or not cost-effective
For additional information, updated documentation, and a list of accessories, refer to Banner Engineering's website,
www.bannerengineering.com/wireless
WARNING:
• Risk of Electric Shock
• Disconnect or turn off the power before installing, removing, or servicing the P15E Node.
• Install and connect the P15E Node in accordance with the National Electrical Code (NEC) and any
applicable local code requirements and supply the P15E Node with an appropriate fuse box or circuit
breaker (see Supply Voltage rating in the Specifications).
• Install the P15E Node at the end of a conduit run.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious injury or
death. This device does not include the self-checking redundant circuitry necessary to allow its use in
personnel safety applications. A sensor failure or malfunction can cause either an energized or de-energized
sensor output condition.
CAUTION: Never Operate 1 Watt Radios Without Antennas
To avoid damaging the radio circuitry, never power up Sure Cross
Watt) radios without an antenna.
Original Document
197408 Rev. C
• Wireless industrial I/O device with two AC/DC relay outputs, two discrete PNP outputs, two 0–
10 V dc analog outputs, two discrete NPN or PNP (selectable) inputs, and two 0–10 V dc
analog inputs
• Supply voltage of 100–277 V ac at 50/60 Hz
• Courtesy power output of 25 W (24 V dc)
• AC power field wireable through a 1/2-inch NPSM port using 1/2-inch conduit, cable gland, or
Mini-style quick disconnect (QD)
• Selectable transmit power levels of 250 mW or 1 Watt for 900 MHz models and 65 mW for 2.4
GHz models
• DIP switches for user configuration
• Frequency Hopping Spread Spectrum (FHSS) technology ensures reliable data delivery within
the unlicensed Industrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, including
fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
.
19 April 2018
®
Performance or Sure Cross MultiHop (1
197408