General Introduction; Install The Antenna; Turn On The Camera - Reolink Argus Eco Quick Start Manual

General Introduction

Built-in Mic
Status LED
Lens
Daylight Sensor
Built-in PIR Sensor
Reset hole
On/off switch
Micro SD Card Slot
Speaker
Antenna
Micro USB Port
Battery Status LED
The LED in Red (Wi-Fi connection failed) The LED in Blue (Wi-Fi connection succeeded)
Blinking: Standby status Blinking: Standby status
On: Working status On: Working status
2 English

Install the Antenna

Turn on the Camera

1. Reolink Argus Eco is turned off by default, please turn it on before setting up the camera.
Please install the Antenna to the
camera. Turn the antenna base in a
clockwize motion to connect. Leave
the antenna in a vertical position for
best reception.
Note:
If the camera will not be
in use for a very long time,
it's suggested to turn it off.
English 3