Marquis Spas DESTINY Owner's Manual page 41

Ozonator Operation
The ozone generator operates when pump 1 is on low-speed in Filter Cycles
and SmartClean™ cycles ONLY. The O3 icon appears to the left of the
temperature display when the ozone generator is operating.
User Preference Settings
Suppress reminders: Displayed as (Sr.n) for no, and (Sr.Y) for yes. When
set to (Sr.Y), reminders are never shown in the display. When set to (Sr.n),
all reminders are shown.
Temperature display in Celsius: Displayed as (tc.n) for no, and (tc.Y) for
yes.
24 hour time: Displayed as (24.n) for no (12 hour AM/PM), and (24.Y) for
yes (24 hour military).
SmartClean™ settings: Displayed as (cc.0) for SmartClean off, (cc.1) 1
hour, (cc.2) 2 hour, (cc.3) 3 hour, and (cc.4) for 4 hour Smart Logic durations.
When the spa is in a SmartClean cycle, the SmartClean LED will illuminate.
To Enter the User Preference Mode
• Press the TEMP+ button
• Press the JETS 1 button (displays (Edt))
• Press the LIGHTS button (displays (USr))
• Press the JETS 1 button (displays (Sr.n))
• Use TEMP + or TEMP– pad to scroll through options
- Sr.n: Reminders not suppressed
- tc.n: Temperature display not in Celsius
- 24.n: 12 hour AM/PM
- cc.1: One hour Smart Logic
• Once the desired selection has been reached, press the JETS 1 pad. The
last number or letter will flash. Use the TEMP + or TEMP– pad to change the
setting. Press the JETS 1 pad to enter selection and return to previous mode.
• Press the LIGHTS pad twice to return to normal operation.
• At any point, if a pad is not pressed within thirty seconds of a previous pad
press, the mode will cancel and the spa will return to normal operation.
SOUNDSATIONS™ AUDIO-READY SYSTEM
Spa location and speaker cord routing
The factory-installed speaker cord located inside the spa's equipment
compartment is 30.48 m long. You must locate the spa close enough to the
audio source to allow the cord to be run so it is not exposed to damage and
does not create a trip hazard.
NOTE: A 61 m long speaker cord is available as an optional replacement for the
supplied 30.48 m cord. Ask your authorized Marquis Spas® dealer for details.
Do not replace the supplied speaker cord with any other type of cord.
WARNING! Risk of electric shock: Audio source must be placed in a protected
location at least 1.52 m from the spa. Do not use a portable stereo. Do not use
home audio equipment outside.
Decide on the best path for the speaker cord and then route the speaker cord
out of the equipment compartment in the most appropriate manner for the
installation.
The speaker cord must be installed by a licensed electrician in accordance with
the National Electric Code and all local building codes. Additional installation
advice from an A/V technician may be helpful or necessary if there are any
special circumstances, such as connecting to unique or complicated home
theater systems.
Soundsations™ components come with a one-year warranty, 90-day labor
coverage. Consult your Marquis Soundsations™/Adagio™ Audio Systems
Limited Warranty for more information about coverage.
Connections
CAUTION! Risk of electric shock: The stereo cord-connection within the
equipment compartment and the supplied 30.48 m cord which is used to
conduct the audio signal to the spa are intended to carry a low voltage (12V)
audio signal supplied by a conventional household-type audio system. The
cord-connection and cord are not to be used for any other purpose.
®
M A R Q U I S S P A S
Strip approximately 5 cm off the outer jacket of the speaker cord.
CAUTION! Before making any connections, turn off the stereo receiver and
unplug it from the power source. Failure to do so may result in damage to the
system.
1. To prepare the end of the speaker cord, strip approximately 5 cm off outer jacket.
2. To prepare the ends of the wires, strip approximately 1 cm of insulation from each
wire. Then twist the bare ends of each wire so there are no loose wire strands.
WARNING! Never use broken or frayed wire, as damage or electrical shock may result.
CAUTION! Exposing too much wire or having wires with frayed ends could
cause wires to touch each other, which could damage the equipment.
3. Wire connections
A. Red = Right (+)
B. Black = Right (-)
C. White = Left (-)
D. Green = Left (+)
NOTE: Do not connect speaker cord to any speaker terminals already in use.
4. Check all connections to the stereo receiver. Make sure all wires are
connected in phase (+ to + and –to –). Correct any wiring problems before
reconnecting the stereo receiver to the power source. Perform a routine
inspection (every three months) of the system to ensure it is operating properly.
If the cord or cord-connection is damaged, if the door to the equipment
compartment shows signs of deterioration, if excessive water is entering the
equipment compartment, or if there are other signs of damage to related
components, turn off the spa and have the damaged component repaired by a
qualified service person.
Recommended components
Use stereo receivers rated from 60 to 120 peak watts per channel and rated
from 8 to 16 ohms.
Soundsations™ audio system has automatic protection circuits to protect
against overload. This circuit activates at high volume levels to reduce output,
causing a decrease in volume. This is normal operation and indicates that the
power input may be exceeding safe levels. If this protection circuit has been
activated, turn down the volume to allow the system to reset itself and resume
normal operation. Sustained listening at high volume settings is not
recommended.
CAUTION! Please read this installation guide completely before the installation.
Failure to follow the instructions in this guide voids all warranties on the
Soundsations™ audio system.
ADAGIO™ AUDIO SYSTEM
Stereo
Adagio is easy to operate with logical push button controls and function keys.
Please refer to the Poly-Planar Marine Audio Center manufacturer's owner's
manual for features, operation, and troubleshooting.
NOTE: Avoid water splashing on the stereo face. Never insert a disk or operate
the stereo with wet hands. Moisture can damage internal components. Water
intrusion into stereo is not covered under warranty. See Poly-Planar owner's
manual for coverage information. Consult your Marquis Soundsations™
Adagio™ Audio Systems Limited Warranty for more information about coverage.
Speakers
Gently push the top of the self-rising speakers to raise them. Hold the speaker
top, avoiding the speaker screens, and gradually rotate the speakers as desired.
To lower the speakers gently push the speaker top until it is completely closed.
Make sure speakers are in the down position before closing the spa cover.
Speaker lift mechanism is manufacturer-warranted against failure to lift due to
manufacturing defects only. Closing the spa cover with speakers in the up
position or forcing the speaker down too rapidly can result in damage.
O W N E R ' S M A N U A L
+
RED
R
BLACK
-
-
WHITE
L
GREEN
+
15