Table of Contents
Advertisement
QUICK START GUIDE - PLEASE READ BEFORE OPERATING THE UNIT
Table of contents
ACT 7 QUICK START GUIDE
System description
2
The ACT 7 comprises a room unit and external heat
exchanger. The interconnecting line which connects the two
3
parts together includes two water pipes, condensed waste
3
water pipe and an electrical supply power cord. Both ends of
the water pipes are fitted with 'quick connect' couplings that
3
open on connection but reseal to become water tight on
4
disconnection. Up to 30m of lines can be joined together.
4
Electrical supply
5
5
As standard, the ACT 7 requires a fused electrical supply (UK
13A, Europe 16A) rated at 230 Volts, ~1N, 50Hz. The ACT 7
5
will operate from a standard domestic wall socket. The size of
5
any extension cable that may be used is 2.5mm
up to a maximum length of 10 metres. For longer lengths
6
4.0mm
cable must be used. If the cable is on a 'cable drum'
2
7
then ensure that it is completely unwound in accordance
with the manufacturer's instructions - serious complications
8
will occur otherwise.
10
12
Note: Most domestic proprietary extension cables are
1.5mm
. This is not sufficient.
2
13
13
Air flow
14
The air outlet at the top of the ACT 7 room unit is fitted with
grilles that allow the angle of air outlet to be adjusted. In
conjunction with the fan speed control switch, the air velocity
and direction can be carefully set up to obtain maximum
coverage of the area being cooled without causing draughts.
An alternative top panel with twin 7" ducts is available.
Care should be taken to avoid outlet air being obstructed as
this will cause the air to rebound around the device resulting
in recirculation and incorrect control of the device. Ideally, the
air should be directed to create a 'blanket' of cold air across
the ceiling area allowing natural convection to drop the air
over the whole area at very low velocity.
minimum
2
3
Advertisement
Table of Contents
