GE SPM Series Instruction Manual page 83

7 TESTING AND TROUBLESHOOTING
Table 7–2: PROGRAMMING EXAMPLE (Sheet 2 of 4)
KEYPRESS DISPLAY
ENTER
,
PF TRIP: –0.85
ENTER to modify
ENTER
,
PF DELAY: 10.0 s
ENTER to modify
ENTER
,
PF DELAY: 5.0 s
ENTER to modify
PF SUPP: 6% FLC
ENTER to modify
ENTER
,
PF MODE: ridethru
ENTER to modify
ENTER
,
PF MODE: resync
SCROLL to change
FCX DELAY: 1 s
ENTER to modify
ENTER
,
AC CT RTG: 10/5
ENTER to modify
ENTER
,
AC CT RTG: 100/5
SCROLL to change
ENTER
,
FL AMPS:
ENTER to modify
ENTER
,
FL AMPS:
SCROLL to change
ENTER
,
LR AMPS:
ENTER to modify
ENTER
,
LR AMPS:
SCROLL to change
ENTER
,
SYNC SLIP: 0.5%
ENTER to modify
GE Power Management
COMMENTS
Change existing value of PF TRIP to new –0.85 value.
Select the setpoint. Use the scroll key(s) to select value of 5.0
seconds and then ENTER to accept new value
Change the existing value of PF DELAY to 5.0
This value will remain as is.
Select the setpoint. Use the scroll keys to move to the PF MODE
setpoint and then ENTER to select the setpoint.
Change the existing value of PF MODE to resync. Use the scroll
keys to select value of resync and then ENTER to accept new
value.
Press the scroll down key to move to the FCX delay setpoint. This
value will remain as is.
SCROLL DOWN key to move to the AC CT RTG setpoint and then
SELECT/ENTER key to select the setpoint.
Change the existing value of AC CT RTG to 100. SCROLL Key(s)
to select the value of 100 then SELECT/ENTER key to accept new
value.
SCROLL DOWN key to move to the FL AMPS setpoint and then
10
SELECT/ENTER key to select the setpoint
Changes existing value of FL AMPS to 56. SCROLL Key(s) to
58
select value of 58 and then SELECT/ENTER key to accept new
value
SCROLL DOWN key to move to the LR AMPS setpoint and then
116
SELECT/ENTER to select the setpoint
Change the existing value of LR AMPS to 226. SCROLL Key(s) to
226
select value of 226 and then SELECT/ENTER key to accept new
value
SCROLL DOWN key to the SYNC SLIP set-point and then
SELECT/ENTER key to select the setpoint
SPM Synchronous Motor Protection & Control
7.5 PROGRAMMING
7-
9
7