Table of Contents
Advertisement
Boiling
•
To boil water, fill the tank with the desired amount
of potable water and set the function switch to ON
(at bottom). The red control light will come on.
•
After boiling temperature has been reached, the
heating coil will automatically shut off and the
function switch will move to the OFF position.
The red control light will go off.
The water's temperature will not be maintained
automatically. To heat the water again, put the
function switch in the ON position (at bottom).
• To distribute prepared hot beverages, place an
appropriate dish (cup, mug, etc.) under the spout.
Press and hold the lever down until the desired
amount of beverage has come out. Release the
lever to automatically close the spout.
CAUTION!
Regularly monitor the level of liquid and refill as
necessary. Never use the device without liquid!
•
The device is equipped with a function protecting it against overheating/operating
when dry. If the device is accidentally turned on without liquid or with too little
liquid, the protection function will be activated and the device will be automatically
shut off.
Leave the device to cool and pour any remaining
beverage through the spout into another container.
Press the RESET button located at the bottom of the
device base. The may now be filled with a beverage
and operated normally.
•
When finished using the device, turn the temperature dial counter-clockwise to the
counter-clockwise to the setting marked ► (or move the function switch up to the OFF
position), disconnect the device from its power source by removing the plug, leave to
cool and then pour out any liquid still inside.
- 26 -
OFF
ON
Advertisement
Table of Contents
