Mobile Application; First Installation - Tele System Hello Quick Start Manual

SMART WiFi HD VIDEO INTERCOM HELLO - QUICK START GUIDE

5. Mobile Application

Hello sends a stream of data to the mobile device (smartphone and/or tablets) so that it can access the remote surveillance
system (data connection). For the management and use of the camera remotely, you need to install on a specific mobile device
application available on AppStore for iOS devices and GooglePlay for Android devices, the èatHOME Control application.
NOTE
A necessary condition for this is that your mobile device be connected to a data network (e.g. 3G). For more information please
contact your mobile network operator.
Through the use of the application you can see up to 4 data streams coming from different devices (Hello and/or video cameras
of the same family, visit the website www.telesystem-world.com to know which products can be used)
Please note that by setting the HD "high definition" video quality for watching on mobile devices you will get a data stream of
greater weight and, in the case of limited available bandwidth, it will cause a greater delay of the images. It is therefore advi-
sable to choose a video resolution in line with the situation and availability of bandwidth to the device.

6. First Installation

If Hello cannot be connected to the net via cable, you can use it in wireless mode (it is recommended to install the supplied
antenna to increase the stability of the connection), you must have a WIFI router and a mobile device (iOS or Android) that
supports this technology.
1. Install the atHOME Control application from AppStore or GooglePlay (depending on the device).
2. Turn on the WI-FI on your smartphone/tablet, launch the atHOME Control application and click + to add a new device;
select "Configure and add a new wireless device".
3. Start Hello in AP mode: Once connected to the power supply, press the "call" button for 5 seconds until you hear a beep, repeat
for 3 times in a row. Hello will restart automatically in AP mode creating a WIFI network (name SSID: IP Port + UID, where UID
is the label applied to the same).
9