Tele System Hello Quick Start Manual page 7

7
SMART WiFi HD VIDEO INTERCOM HELLO - QUICK START GUIDE
Power supply: The videophone "Hello" power supply comes from the indoor unit which in turn must be connected to the power
supply (100 ~ 240V, 50/60 Hz).
Connect the red and black cable to the indoor unit using the supplied adapter, respecting the polarity and the colors.
By wire connection: If the Wi-Fi signal is not available at the place of installation
or you prefer a connection via cable, connect the Rj45 adapter cables as descri-
bed in "Figure 2", the adapter will allow the connection of "Hello" to the Internet
network via RJ45 cable.
Figure 2
NOTE
The adapter has two different wiring instructions ("A" and "B") to allow you to use the two standard EIA/TIA-568A and
EIA/TIA-568B. While connecting the router, you must remain consistent with the standard used in the home network.
The wiring scheme most widely used is the EIA/TIA-568B; you should check your system before connecting the adapter.
Electric lock release: The standard setting of the lock release system is "normally open" (NO). This means that the circuit
(marked as XX) is open. If you press the Unlock button the circuit is closed by releasing the lock.
Speaker volume: From the back of the monitor, using a small screwdriver, you can adjust the volume by turning the potentio-
meter (marked with the letter A in "Figure 1")