12.1 CoolDX 08-40, all capacity variants, and size 60, capacity variant 1 4.2 To connect the communication cable 12.2 CoolDX 60 Capacity variant 2 12.3 CoolDX 60 Capacity variant 3 13 Commissioning Record www.swegon.com We reserve the right to alter specifications.
Management Systems compressor and a scroll compressor, all other sizes/output variants contain two piston compressors each. We at Swegon are deeply involved in the maintenance of our certified quality management system defined by ISO 9001 and our certified environmental management sys- Completely direct-acting system tem defined by ISO 14001.
This can be done with- The pressure and the temperature decrease as the refri- out removing the protective sock. gerant in fluid form flows through expansion valves VET1 and VET2. www.swegon.com We reserve the right to alter specifications.
Other modifications in the unit should only be made by service personnel trained by Swegon. 2.2 Risks 2.5 Identification decals The unit identification decal indicating type designation, Warning serial number, refrigerant volume, etc.
(or in the base frame of the cooling unit if the unit is not delivered on a pallet). See sketch. www.swegon.com We reserve the right to alter specifications.
Cooling coil in upper level/GOLD fan arrangement 2 Left hand version Cooling coil in upper level/GOLD fan arrangement 1 Cooling coil in lower level/GOLD fan arrangement 2 Outdoor air Supply air Extract air Exhaust air www.swegon.com We reserve the right to alter specifications.
CoolDX unit. It may be necessary to extend the communication cable and necessary tubing (not included in the supply) de- pending on the distance between the GOLD unit and the CoolDX unit. www.swegon.com We reserve the right to alter specifications.
The cooling unit is equipped with a drain tray below the Position and secure the hoses by means of bundling straps, cooling coil for collecting condensate that drips from coil for example. surfaces. www.swegon.com We reserve the right to alter specifications.
GOLD air handling unit and install the mats from this side. Cross section A-A Open the inspection doors. Fit the condensation barrier mat onto the interior surfaces of the connections between the GOLD unit and the CoolDX. www.swegon.com We reserve the right to alter specifications.
Then lead the communi- cation cable in a secure manner through the rubber sleeve and from the CoolDX to the junction (wiring) hood of the GOLD. www.swegon.com We reserve the right to alter specifications.
Set the safety isolating switch to the ON position. • Start the CoolDX as described in Section 5.1.2 Starting up. ALARMS For a description of the alarms, see the Operation and Mainte- nance Instructions for the GOLD. www.swegon.com We reserve the right to alter specifications.
If refrigerant is exposed to fire or in some other way 7.4 Servicing becomes superheated in the atmosphere, poisonous gases can form. Only service personnel trained by Swegon shall be permit- ted to modify the cooling unit. www.swegon.com We reserve the right to alter specifications.
One or several bubbles appearing when the cooling unit is started up, operation at reduced capacity or normal operation need not necessarily indicate a refriger- ant deficiency. www.swegon.com We reserve the right to alter specifications.
1250 2253 2353 2075 1600 x 800 Supplied on 100 mm high support feet. Can be removed or left on when the unit is in place. Has provision for adjustable support feet www.swegon.com We reserve the right to alter specifications.
There are many factors that influence what size of cooling unit is required. The CoolDX units have been designed to enable them to meet many different prerequisites. For correct sizing we refer to our ProUnit unit selection program. www.swegon.com We reserve the right to alter specifications.
6. IQnomic Plus, control unit. 7. Phase sequence monitor, applies to size 60, capacity variant 2 only. 8. Transformer, 400/230 V for control voltage 9. Fuse, 230 V, operating voltage. 16 17 22 23 10 11 www.swegon.com We reserve the right to alter specifications.
Q = Electrical circuit load separator, connection point for supply voltage Mx = Compressor PSC = Controls for phase sequence BPx = Low and high pressure switch BPx-x = High pressure switch Hx = Crankcase heater www.swegon.com We reserve the right to alter specifications.
Mx = Compressor PSC = Controls for phase sequence BPx = Low and high pressure switch BPx-x = High pressure switch Hx = Crankcase heater TP = Thermal overload protection for scroll compressor www.swegon.com We reserve the right to alter specifications.
Page 20
Mx = Compressor PSC = Controls for phase sequence BPx = Low and high pressure switch BPx-x = High pressure switch Hx = Crankcase heater TP = Thermal overload protection for scroll compressor www.swegon.com We reserve the right to alter specifications.
Electrical connections installed according to instructions Control cable from CoolDX to GOLD connected according to instructions Direction of rotation of compressor 2 checked (Applicable to CoolDX, size 060, capacity variants 2 and 3) www.swegon.com We reserve the right to alter specifications.
Page 22
40-2 12,0 A 27,0 A 40-3 22,0 A 36,0 A 60-1 15,5 A 36,0 A 60-2 22 A 35,0 A 60-3 36,0 A 50,0 A Function selector switch, IQnomic Plus Position 6 www.swegon.com We reserve the right to alter specifications.