Advertisement
5.Connected to Vehicle
»
NOTE: Do not keep EasyDiag Pin Connector plugged into your
vehicle overnight, be sure to always remove connector once
testing and/or diagnosis is complete. Failure to do so may result
in drained or weakened battery.
Step 1: Locate the vehicle's DLC socket. It is usually located under the
dashboard, towards the driver's left knee area.
Step 2: Plug the EasyDiag connector into DLC socket. The connector's power
indicator will light up to signify communication.
NOTE: Please turn off the ignition switch before connecting and
then turn the key to the ON position after the EasyDiag has been
plugged in.
6. Start to Diagnose
»
Step 1: Open the EasyDiag app, then go into [Settings], select the proper Serial
Number.
Step 2: Select the desired car brand.
Step 3: Pair with the Bluetooth named by the selected serial number.
NOTE: For iOS device, Bluetooth pairing should be done in
the first step.
Step 4: Select the car brand again and then select the software version.
Step 5: Refer to the on-screen instructions to diagnose.
Note:
1. An audible beep will be heared once the EasyDiag is ready to
be used.
2. For more details, please refer to the user's manual.
3. The illustrations herein are for reference only and are subject
to change based on the Smart Device you are using and/ or
software updates.
8
Advertisement
