Add or remove shims as required to level the
4
cart.
5
Tighten the nut using the ¾" open-end wrench.
6
Stand cart upright and inspect. If cart is not level, repeat steps 1 through 3 as necessary on the other casters.
!
WARNING:
Do not install anything except the shims between the caster and the support bracket. Doing so can create an
unsafe load on the caster stud resulting in damage that may cause the cart to tip.
© 2009-2018, Cornelius Inc.
Table 2. Installation Procedure
- 3 -
Viper Cart Installation Instructions
Figure 3.
Figure 4.
Publication Number: 620043075INS