Advertisement
Viper Cart Installation Instructions
C
I
ART
NFORMATION AND
The Viper unit may be mounted on a mobile cart (Cornelius part no. 620043075 / 620066849[Red cart] for 2-barrel
unit, 620053990 / 620066850[Red cart] for 3-barrel unit and 620046556 / 620066851[Red cart] for 4-barrel unit)
which allows some movement of the unit for service and cleaning. There are four captive nuts on the bottom of the
Viper to accommodate four 3/8-16 bolts. These bolts must be installed to secure the unit to the cart.
carts are designed with movable wheels that act as outriggers to provide stability to the unit when it is being
2 FL
moved.
!
WARNING:
The above listed mounting bolts must be installed and the wheels extended and locked in the outboard position
prior to moving the unit.
Failure to comply could result in serious injury, death or equipment damage.
Caster Installation:
Cart is supplied with three (3) shims under each front swivel caster. Six (6) additional shims are also supplied loose
in a plastic bag. In the case where the cart is not level, follow the instructions in the following table to install the
shims.
3- Flavor and 4- Flavor Carts are supplied with two (2) shims under each front swivel caster. Four (4) additional
shims are also supplied loose in a plastic bag.
Step
1
Unpack the Kit
Turn the cart upside down and locate the holes
2
for the casters on the bottom of the cart.
Using a ¾" open-end wrench, loosen the nut on
3
the bottom of the swivel caster.
Publication Number: 620043075INS
M
OUNTING
Table 2. Installation Procedure
Action
- 2 -
Figure 1.
Figure 2.
© 2009-2018, Cornelius Inc.
Advertisement
