Gantner BENZIG M1 Fancier Manual page 69

BENZING M1 – Fancier
MENU FUNCTIONS
• Selecting the Printer
[Settings] -> [Printer] -> [SELECT]
A list of the available printers will be displayed.
PRINTER
Standard
Matrix
PC-Simulation
STA-Standard
QUIT
[ ] or [
[ ]
[OK]
With the selection "PC-Simulation" you have the possibility to display the print-out on a
connected PC before it is printed. Therefore the software "PrtSim.exe" has to be installed
and started on the PC. If you then print with the BENZING M1, the print-out will be shown
on the PC screen. From the PC you can then send the print-out to a printer that is
connected to the PC.
• Online Mode of Printer
[Settings] -> [Printer] -> [ONLINE]
With the BENZING Station it is possible to print arriving pigeons automatically. Therefore
the following points must be fulfilled:
- A loft antenna must be connected at the BENZING Station.
- A printer must be connected at the BENZING Station.
- STA-Standard or STA-Matrix must be set for the printer mode (see above).
- Online printing must be activated (will be described below).
If those conditions are fulfilled and a pigeon lands on a loft antenna (i.e. a pigeon ring is
read), the BENZING Station will send a text line with arrival and pigeon data to the
connected printer.
HB_BENZING-M1_ZUECHTER-EN_20-.doc
GANTNER Pigeon Systems GmbH
11:23:58
.
OK
] - Move cursor mark to the desired printer
- Select the marked printer -> marker "O" will be set (to " ")
- Confirmation of the printer selection. Only after this step the
printer selection will be saved!
(symbol " ")
Selected printer
Cursor mark
The printers "STA-Standard" and "STA-Matrix"
are settings for the BENZING Station
Only displayed after a new printer has been
selected
67