Table of Contents
Advertisement
BENZING M1 – Fancier
INSTALLATION AND INITIAL OPERATION
The following must be observed during installation:
• In a fancier's system with BENZING Antenna Controllers the Power Supply Unit
!
• After having plugged-in the power supply unit, the green display "Power
• For power supply the included BENZING M1 Power Supply Unit should always
• Before plugging in the power supply unit please check if the installation
• When operated in battery mode the BENZING M1 cannot be used with a
• The plugs of the connection cable must be fitted tightly into the sockets. If
HB_BENZING-M1_ZUECHTER-EN_20-.doc
GANTNER Pigeon Systems GmbH
must always be plugged into the corresponding jack of the M1 Fancier Cable. The
socket
on the BENZING M1 will not be used in this case, as power supply of
the Antenna Controllers and the EFA EXPRESS Antennas would be impossible.
supply ON" on the plug of the M1 Fancier Cable must light up (see (G) in
figure 3.4) and also the blue LED 'Power' on the Antenna Controller(s) must
light up. This indicates that the power supply is correctly provided.
be used or a similar power supply unit of an equivalent type.
corresponds to the figure 3.4. Make sure that before connecting the BENZING
M1 to the mains humidity has not found its way into the case of the BENZING
M1 and that the device is being operated according to the conditions of use
mentioned in section 3.1.
fancier system (which means with connected Antenna Controller and loft
antennas), as the power supply would not be sufficient.
interference with the antennas occurs, check these connections!
23
Advertisement
Table of Contents
