Table of Contents
Advertisement
BENZING M1 – Fancier
INSTALLATION AND INITIAL OPERATION
The following must be observed during installation:
•
!
•
•
•
•
•
•
HB_BENZING-M1_ZUECHTER-EN_20-.doc
GANTNER Pigeon Systems GmbH
In a fancier's system the power supply unit must always be plugged into the
corresponding jack of the M1 Fancier Cable. The socket
M1 will not be used in this case, as power supply of the loft antennas would be
impossible.
After having plugged in the power supply unit, the green LED display
"Power supply" on the plug of the M1 Fancier Cable must light up (see (G)
in figure 3.1). This indicates that the power supply is correctly provided.
Connection to the power mains should always be provided near the antennas.
For power supply the included M1 Power Supply Unit should always be
used or a similar power supply unit of an equivalent type.
Before plugging in the power supply unit please check if the installation
corresponds to figure 3.1. Make sure that before connecting the BENZING
M1 to the mains humidity has not found its way into the case of the
BENZING M1 and that the device is being operated according to the
conditions of use mentioned in section 3.1.
When operated in battery mode the BENZING M1 cannot be used with a
fancier system (which means with connected loft antennas), as the power
supply for the antennas would not be sufficient.
The plugs of the connection cable must be fitted tightly into the sockets. If
interference with the antennas occurs, check these connections!
on the BENZING
19
Advertisement
Table of Contents
