Gantner BENZIG M1 Fancier Manual page 36

BENZING M1 – Fancier
OPERATION
At the multi-fancier device a differentiation between the individual fanciers is necessary.
Therefore a menu for the fancier selection will be displayed. All the following menus will
indicate the respective active fancier using a number (1-4) on the display at the above left.
Each finished procedure corresponds only to the active fancier and has no influence
whatsoever on the other fanciers.
Selection of the fancier has to take place at the following:
- Display of Arriving and Missing Pigeons (See Section 5.1.3)
[MENU] -> [RACE] -> [LIST]
In the arriving list and the list of missing pigeons only the pigeons of the selected fancier
will be displayed.
- Pigeons (See Section 5.3)
[MENU] -> [PIGEONS]
Displaying the registration list of the pigeons, editing the pre-registration list and deleting
pigeons is fancier dependent and applies only to the actual fancier.
- Enter the Name of the Fancier (See Section 5.4.6)
[MENU] -> [Settings] -> [Fancier Name]
For each of the 4 possible fanciers a name can be entered.
- Input phone number for Sending SMS and Sending Test-SMS (See Section 5.4.10)
[MENU] -> [Settings] -> [Benzing STATION] -> [SMS]
For each of the four possible fancier a unique phone number can be defined. A Test-SMS
can be sent directly to a selected fancier.
Selection of the fancier is not required with the following steps:
- Training (See Section 5.2)
When starting the training all free pigeons of all fanciers will be basketed for the training.
- Discharge Pigeons (Finish the Race) (See Section 5.1.4)
For all fanciers the pigeons which were basketed for the race will be discharged.
- Calculation of Velocity for the Races (See Section 5.1.5)
By entering the distance between the place where the race starts and a pigeon loft the velocity
of the pigeons can be calculated. This setting is only possible for all fanciers at once.
34
HB_BENZING-M1_ZUECHTER-EN_20-.doc
GANTNER Pigeon Systems GmbH