Luxor Endura LE27C Instruction Sheet

Instruction Sheet - Endura Mobile Cabinet Tables
Models LE27C
Customer Service Department
Luxor
2245 Delany Road
Waukegan, IL 60087
Ph: 847/244-1800 • 800/323-4656
Fax: 847/244-1818 • 800/327-1698
If you did not get an
electric assembly with
your cart start by closing
the electric plug housing
in the handle of the top
shelf as illustrated below.
NOTE: Model LE-27C had double doors.
PLUG
HOUSING
COVER
5
Install door panel same as back panel with door
handle at top. Be sure door opens outward and
door frame is also placed between legs and nested
flush on the shelf floor.
LE27C
RUBBER BAND
BOTTOM
SHELF
LEG POST
1 2
With bottom shelf facing up push all four legs Install the side panels first. Slide panels down
onto leg posts. Using rubber mallet hammer legs between legs until they are nested inside the
firmly into position. Legs must be seated (flush) shelf lip and flush against the shelf surface.
against the shelf surface. Place rubber band Rubber band will hold legs and side panels in
around legs to aid in the assembly of cabinet place while installing back panel and front door.
side panels and doors.
TOP
SHELF
GUIDE
COVER
6
7
Begin seating of top shelf by holding door panel,
Install grommet ring and grommet cap into top shelf.
leg and side panel as illustrated. Gently tap corner
For tables with electric assembly, snap off cord
posts into legs until all posts are partially inserted
guide cover from grommet cap to allow equipment
into legs. Repeat hammering action more firmly
plug entry. Insert grommet cap into grommet ring.
going around to each corner, being certain that
each panel nests inside the lip of the top shelf.
Repeat this action until top shelf is fully nested.
Models LE27C
1 - Top shelf w/handle
1 - Bottom shelf w/caster sockets
4 - Legs
2 - Cabinet side panels
1 - Back Panel
1 - Door in frame
1 - Power cord
4 - Casters 2 with brake
8 - 1 3/4" machine screws
Tools Required:
Rubber mallet
TOP VIEW
GROMMET HOLE
GROMMET RING
STOVE
LEGS
BOLTS
SIDE
PANEL
SIDE VIEW WITH
PANEL SEATED
INSIDE SHELF LIP
3
Install the back panel in the same manner as side
panels. Install grommet ring into grommet hole.
Insert two stove bolts as illustrated through "U"
bracket into back panel and through slots in cord
wrap bracket. Align the cord wrap bracket onto
stove bolts from the outside of back panel, and
secure with two kep nuts.
CORD
GROMMET RING
8
Push the four casters firmly into the holes in
each corner of the bottom shelf. Important: cast-
ers must be fully seated. Tap firmly with rubber
mallet to properly seat casters. Turn your
Endura Table right side up.
PARTS LIST
1 - Grommet Cap
1 - Cord guide cover
2 - Grommet rings
1 - Rubber Band
4 - Small 'U" brackets
1 - Large "U" bracket
1 - Cord wrap bracket
2 - Stove bolts
KEP
NUT
GROMMET
HOLE
CORD
WRAP
BRACKET
"U"
BRACKET
"U"
BRACKET
INSIDE BACK
PANEL
4
Press 3-outlet power cord into "U" bracket and feed
remaining cord through grommet hole and wrap
remaining cord around cord wrap bracket. For safety
and neat appearance, secure cord plug to cord with
plug snap.
PLACE LOCKING CASTERS
AS ILLUSTRATED
BACK
FRONT
CORD WRAP
BRACKET
PLUG SNAP
OUTSIDE
BACK PANEL