Advertisement
EvolutionCross-Laser 8P PowerBright
Manual re-adjustment:
Steeper slopes can be set using the angle plate, which is available as an
optional extra (product ref. 080.75). To this end you need to use a crank
tripod, such as the 300 cm professional crank tripod, product ref. 080.34.
TIP: Allow the device to align itself automatically and set the angle plate to
the zero position. Next, deactivate the automatic sensor by pressing the H
slope button (and holding for 3 seconds). Finally, incline the device to the
angle you require.
slope
3 sec
(16)
auto LED status indicator
Automatic mode (auto)
auto
Continuous
OK
TIP: Switch the required laser lines on before you activate the slope function.
Positioning laser lines
The top section of the laser unit can be turned on the plinth to align the
lasers approximately. The vernier adjustment mechanism (4) can be used to
position the lasers precisely. The freely rotatable horizontal circle (3) makes
it easy to turn the device to the required angle. Simply set the scale to zero,
then rotate the device to the angle you want.
auto
Rapid
Set-up phase
Slope function (slope)
auto
Every second
X axis
ENGLISH
auto
Very rapid
Y axis
15
Advertisement
