LaserLiner EvolutionCross-Laser 8P PowerBright Operating Instructions Manual page 6

EvolutionCross-Laser 8P PowerBright
Manual Slope function
This function deactivates the automatic sensor, which enables slopes to be
set. Press the H slope button and hold it down for 3 seconds until the auto
LED starts to flash very rapidly. The V1, V2 buttons are used to re-adjust the
slope by means of a motor. The H slope button (pressed briefly) is used to
switch over between axes. IMPORTANT: Since the automatic sensor is not
active, horizontal and/or
3 sec
(16)
(9,12)
(16)
(9,12)
(16)
3 sec
(16)
(9,12)
(16)
(9,12)
(16)
14
slope
slope
ENGLISH
auto
3 sec
auto
3 sec