Advertisement
Battery (NiMH) charging
• Charge the batteries (NiMH) fully before using the laser unit. Insert only
rechargeable (i.e. secondary) batteries into the charging unit. Be sure that the
batteries are marked with the label „RECHARGEABLE".
• Insert the rechargeable batteries into the charger and connect the charger to the
mains power supply. Observe the charger operating instructions. As soon as the
rechargeable batteries are charged up, disconnect the charger from the mains
power supply.
• Insert the rechargeable batteries (NiMH) into the laser unit. Do this by opening the
battery compartment (2) and inserting the batteries according to the symbols. If
the status indicator (13) flashes, the rechargeable batteries need to be replaced.
Attention: Only insert rechargeable batteries into the charger – risk of
explosion! Used batteries must not be disposed of with regular domestic
waste; instead, they can be deposited at a collection point for batteries or
hazardous waste.
Setting up
• Press the „ON/OFF" switch (14).
• The automatic sensor aligns the device without any need for
operator intervention. To accomplish this, two electronic sensors
are used to detect the X and Y axes. The working angle ist ±
2,5°. During the set-up phase, the auto LED (15) flashes rapidly.
When levelling is complete, the auto LED lights up continuously.
• Switch the lasers on using the H slope, V1 or V2 buttons (press
briefly). Maximum visibility of the laser line is obtained when
hand receiver mode is switched off (button 11, indicator
light 10 off).
Note: If the unit is placed at an excessive angle (out of its 2,5° range),
the lasers will blink. If this should be the case, align the unit roughly with
the levelling feet (7) or place it on a more level surface.
Anti-shake function
The automatic sensor continuously levels the devices, even if they are in motion.
This makes device alignment easier, as it enables the laser to be set to a
required height by means of a crank tripod or a wall bracket, for example.
It also means that the laser can be used on vibrating surfaces and in windy
conditions. IMPORTANT: Precision is adversely affected during the set-up phase.
EvolutionCross-Laser 8P PowerBright
ENGLISH
13
Advertisement
