Page 1
____________________________________________________________________________________ OWNER’S MANUAL INSTALLATION, OPERATION, & PARTS MAGIC CLEAN / SCUBA / WHALY / AQUACRITTER ABOVE-GROUND AUTOMATIC POOL CLEANER ® Hayward automatic pool cleaners are specifically engineered for the demanding requirements of today’s above-ground swimming pools. To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and completely.
Above-Ground Automatic Pool Cleaners __________________________ Important Safety Information IMPORTANT SAFETY INSTRUCTIONS When installing and using electrical equipment always follow basic safety precautions. CAREFULLY READ AND FOLLOW ALL INSTRUCTIONS IN THIS OWNER’S MANUAL AND ON EQUIPMENT. KEEP SAFETY LABELS IN GOOD CONDITION AND REPLACE IF MISSING OR DAMAGED.
SAVE THESE SAFETY INSTRUCTIONS General Information Introduction This manual contains information for the proper installation and operation of Hayward’s automatic pool cleaners. The instructions in this manual MUST be followed precisely. Features • Patented SmartDrive programmed steering system ensures the entire bottom of the pool is cleaned quickly and completely •...
Clean or backwash the filter, and clean the pump strainer basket prior to installing your Hayward automatic pool cleaner. NOTE: If the pump does not have a strainer basket, it is absolutely necessary that the Hayward AEW560 Leaf Canister be installed. The Hayward AEW560 Leaf Canister can be purchased separately from your local Hayward dealer.
Page 5
If the total hose length is not long enough, it will be necessary to purchase additional hose sections from your Hayward dealer. The hose length supplied (9,75 meters) has been determined to be sufficient for the majority of pools, nationally. If your hose requirement is more than this, you must purchase additional hose sections for your cleaner to work properly.
“eyeball” fitting, it will be necessary to purchase a Hayward AEXK19A Return-line Diverter from your Hayward dealer. Now that your cleaner is installed and operating, enjoy a carefree pool. It is necessary to run your cleaner only long enough to clean the pool bottom, not for the entire filter cycle. It is, however, a good idea to run your cleaner daily, as this is an excellent way to improve water circulation and chemical distribution in the pool because your cleaner functions as a moving “bottom drain”.
Check the Bumper Ring for free rotation. Check filter system for water flow and re-install the cleaner. If the cleaner is getting stuck, contact your Hayward dealer. Under no conditions should the cleaner remain in the pool connected to the filter system if the problem of getting stuck or “hung up”...
Head Assembly for Scuba AEXV457W Head Assembly for Whaly including Tail AEXV457WT Tail Assembly for Whaly AEXV513BK Screen, Black AEXV443 Magic Clean Spots, 4 lg. & 2 sm. AEXV070 Cone Gear AEXV309 Intermediate Gear Shaft AEXV301 Intermediate Gear AEXV068 Spindle Gear Screw...
Page 10
Call (33) 825 000 549 for the name and address of the nearest Factory Service Center. HAYWARD POOL PRODUCTS will at its option, repair or replace all defective CLEANER parts covered by this Limited Warranty at its own cost and expense and return same to consumer freight prepaid.
Need help?
Do you have a question about the MAGIC CLEAN and is the answer not in the manual?
Questions and answers