Honda CRF450L 2019 Owner's Manual & Off-Road Handbook page 99

7. Make sure that the timing mark (11) on the cam
sprocket aligns with the camshaft holder
mating surface (12) of the cylinder head.
(12)
Align
(11)
(11) timing mark
(12) camshaft holder mating surface
8. Make sure that the dowel pins (13) are installed
into the camshaft holder (14).
(13)
(14)
(13) dowel pins (14) camshaft holder
9. Install the set rings (15) on the camshaft
bearing grooves (16).
NOTICE
Do not let the set rings fall into the crankcase.
(15)
(15) set rings
(16) camshaft bearing grooves
10. Apply engine oil to the camshaft holder bolt
threads.
Install the camshaft holder (17) with the "
mark (18) facing forward.
Install the camshaft holder bolts (19) (20) and
tighten the camshaft holder bolts to the
specified torque:
11 lbf·ft (15 N·m, 1.5 kgf·m)
Tighten the camshaft holder bolts in a crisscross
pattern in two or three steps.
(19)
(17)
(20)
(17) camshaft holder (19) camshaft holder bolts (long)
(20) camshaft holder bolts (short)
(18) " " mark
Valve Clearance
11. Remove the tensioner stopper (21) from the
cam chain tensioner lifter.
(16)
(21) tensioner stopper
12. Make sure that the piston is at TDC on the
"
compression stroke (page 88).
Check that the timing mark (11) on the cam
sprocket aligns with the camshaft holder
mating surface (12) of the cylinder head.
If the timing mark doesn't align with the camshaft
holder mating surface, insert the tensioner stopper
into the cam chain tensioner lifter (page 90) and
then remove the cam chain and realign the timing
mark.
Align
(18)
(11) timing mark
(12) camshaft holder mating surface
(21)
(11)
Align
(12)
93
Servicing Your Honda