How To Use The Liquid Crystal Display (Lcd) - Hitachi NEXT Series Instruction Manual

3.3 How to Use the liquid Crystal Display (LCD)

3.3.1 How to Move between the Various Displays
■ Monitoring Displays
There are three monitoring displays: M1, M2, and
M3. To move between these displays, press the
MONITOR button.
■ Monitoring Display（ p.12）
M1 Monitoring Display
M2 Monitoring Display
■ Message Display（ p.13）
M3 Monitoring Display
モニタ
MONITOR
3. OPERATING THE DSP [How to Use the Liquid Crystal Display (LCD)]
モニタ
MONITOR
モニタ
MONITOR
■ Menu Displays
Follow the bottom line message on the display.
■ Function Menu Display（ p.16）
Function Menu Display
機能
FUNCTION
モニタ
MONITOR
IMPORTANT
About the LCD Backlight
(1) In the event that no button has been used for 10
minutes, the LCD backlight automatically turns OFF
for protection to the display panel. It comes ON
again if any button is pressed, other than the
START and STOP buttons.
(2) If an event happens while the LCD backlight is off,
the backlight automatically turns ON and stays ON
as long as the event exists. Remote and instant
stop mode can't be set by the LCD monitor.
Set after referring to "3.4 How to Use the Digital
Monitor." ( page 21)
■ Message Display
There is only one message display: M3 (the contents,
however, vary from time to time). It is available only
when some event (air compressor alarm or shutdown,
maintenance notice, etc.) has occurred. Once an event
happens, however, the M3 message display appears
immediately and automatically. From the M3 display,
pressing the MONITOR button will switch the LCD
to the M1 or M2 monitoring displays; but after
approximately ten (10) seconds, the M1 or M2 moni-
toring displays will revert back to the M3 display.
13