Installing Batteries; Using The Ac Adapter - HoMedics THERA-P BPA-200 Manual

INSTALLING BATTERIES

Note: It is recommended that you use batteries only
for travelling or when it is not possible to use the
AC adapter.
1. Extend the tray so that the battery cover is fully
exposed.
2. Press down on latch and lift the battery cover
towards you to open the battery compartment.
3. Install or replace 4 "AA" sized batteries in the
battery compartment according to the indications
inside the compartment.
4. Replace the battery cover by clicking in the
bottom hooks first, then push in the top end of
the battery door.
Replace the batteries if:
1. The weak battery symbol appears on the display.
2. Nothing appears on the display when the power is
switched on.
Battery
Cover
Slide-Out
Tray
11
As the supplied batteries are for test only, they may be
discharged earlier than batteries you buy in stores.
Replace the batteries in pairs. Remove batteries when
unit is not in use for extended periods of time.
Note: Batteries are hazardous waste. Do not dispose
of them together with the household garbage.

USING THE AC ADAPTER

Note: • Please unload the batteries when operating
with the AC adapter for an extended period
of time. Leaving the batteries in the
compartment for a long time may cause
leakage, which may lead to damage of the
unit.
• No batteries are needed when operating with
the AC adapter.
1. Connect the AC adapter with the AC adapter jack
in the back of the unit as shown below.
2. Please use only the AC adapter included with
this monitor.
Connect AC
adapter here
AC Adapter
Input: 120V 60Hz
Output: 12V DC 500mA
12