Date & Time Set Procedure; Applying The Cuff - HoMedics THERA-P BPA-200 Manual

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button
located on the back of the monitor.
2. The display will show a blinking number showing
the hour. Change the hour by pressing the
button. Each press will increase the number by one
in a cycling manner. Press the Set button
to confirm the entry, and the screen will show a
blinking number representing the minutes.
3. Change the time and date as described in Step 2
above, using the
numbers and the Set button
entries.
4. A "0" will reappear as the blood pressure monitor is
ready for measurement again.
repeat process to set time and date
again
button to change the
to confirm the
Press the button
blinking hour
increasing hour
confirm the entry
13

APPLYING THE CUFF

,
1. If the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the
metal D-ring in order to form a loop.
End of cuff
D-ring
2. Plug the cuff tube into the left side of the unit.
Insert plug here
14