Table of Contents
Advertisement
EN
The heater does not heat.
Check that the fuses to the heater are in good
·
condition.
Check that the connection cable is connected
·
( 3.4.).
FG: Turn the timer switch to the "on" section
·
( 1.3.1.).
Turn the thermostat to a higher setting ( 1.3.4.).
·
FG: Check that the overheat protector has not gone
·
off. The timer works but the heater does not heat.
( 3.5.)
FG90: Check the functioning of the contactor. A
·
"click" should be heard from the contactor when
you turn the timer switch to the "on" section
( 1.3.1.).
The sauna room heats slowly. The water thrown on the
sauna stones cools down the stones quickly.
Check that the fuses to the heater are in good
·
condition.
Check that all heating elements glow when the
·
heater is on.
Turn the thermostat to a higher setting ( 1.3.4.).
·
Check that the heater output is sufficient ( 2.3.).
·
Check the sauna stones ( 1.1.). Too tightly piled
·
stones, the settling of stones with time or wrong
stone type can hinder the air flow through the
heater, which results in reduced heating efficiency.
Check that the sauna room ventilation has been
·
arranged correctly ( 2.2.).
The sauna room heats quickly, but the temperature of
the stones remain insufficient. Water thrown on the
stones runs through.
Turn the thermostat to a lower setting
·
( 1.3.4.).
Check that the heater output is not too high
·
( 2.3.).
Check that the sauna room ventilation has been
·
arranged correctly ( 2.2.).
Panel or other material near the heater blackens quickly.
Check that the requirements for safety distances are
·
fulfilled ( 3.1.).
Check the sauna stones ( 1.1.). Too tightly
·
piled stones, the settling of stones with time or
wrong stone type can hinder the air flow through
the heater, which may result in overheating of
surrounding materials.
Check that no heating elements can be seen
·
behind the stones. If heating elements can be seen,
rearrange the stones so that the heating elements
are covered completely ( 1.1.).
Also see section 2.1.1.
·
The heater emits smell.
See section 1.2.
·
The hot heater may emphasize odours mixed in the
·
air that are not, however, caused by the sauna or
the heater. Examples: paint, glue, oil, seasoning.
The heater makes noise.
FG: The timer is a mechanical device and it makes a
·
ticking sound when it is functioning normally. If the
timer ticks even when the heater is switched off,
check the timer's wiring.
Occasional bangs are most likely caused by stones
·
cracking due to heat.
The thermal expansion of heater parts can cause
·
noises when the heater warms up.
CZ
Kamna nehřejí.
·
Zkontrolujte jestli jsou jističe v pořádku.
Zkontrolujte připojený kabel – viz. 3.4.
Oprava: Otočte časovač do polohy ON
(1.3.1.)
Otočte termostat do maxima ( viz. 1.3.)
Oprava: Zkontrolujte pokud kamna
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
Advertisement
Table of Contents
