Table of Contents
Advertisement
Checklist for assembly and electrical installation of the safety module
Device type/equipment identification
Version: HW/FW/FW
Author
Remark
No. Requirement (mandatory)
1
Was assembly and installation completed according to the specifications
(specifications from the planning phase or according to the user manual)?
2
Was the safety module installed in the control cabinet (IP54)?
3
Do the cable cross sections correspond to the specifications?
4
Are requirements for the actuators and cable installation observed according to
the SIL/SIL CL CL/Cat./PL to be achieved and is the corresponding
implementation observed?
5
If error prevention (e.g., cross circuit to external signals) has been defined:
Have the conditions for error prevention been implemented?
6
Is the transmission speed set correctly according to the specifications?
7
Is the operating mode set correctly according to the specifications?
8
Is the address set correctly according to the specifications?
No. Requirement (optional)
9
GFK-2731
B 2.2
Assembly and electrical installation
Chapter B
Date
Test engineer
Yes
Yes
No Remark
Date
Date
Remark
Signature (author)
Signature (test engineer)
B
B-9
Advertisement
Table of Contents
